Note – Individual Component – For Makers/Integrators or Repair
This is the main board of the Kytech Industries Custom Sound Device V1 unit. This component is the powerhouse and brains of the device, for bringing in sensor and battery connections and hosting the SD card. The program pre-loaded onto the board executes the many functions of the Custom Sound Device. The solder connection points for a speaker (8 Ohm, parallel bridge-tied load 50W max power) allow the user to create their own aural experiences. Build your own unique sound-loaded blaster and immerse yourself in the action like never before. Let your imagination run wild!
Coupled with a Kytech Industries sensor (purchased separately, or if also needing a speaker get the Makers Kit), or by wiring to an electronic switch (MOSFET, Electronic fire control unit, raw trigger contacts) and some configuration on the device SD card, you can trigger the sounds.
NOTE: Battery not included! See specifications/recommendations below
Features:
- Load any .wav sound file for playback
- Selectable Playback Modes
- External Trigger Compatibility
- Volume Adjustment
- Micro SD Compatibility
- External Audio Output – 3.5mm Audio Jack
Specs:
- Input Voltage: 6.5 – 15V
- Trigger Input Voltage: 5 – 13V
- Low Voltage Cutoff 2S: 6.1V
- Low Voltage Cutoff 3S: 9.1V
- Amplifier Gain (on audio signal): 26dB
- Max Amplifier Power: 50 Watts
- Idle Power Consumption: 0.5 Watt
- Dimensions (PCB)(mm): 65.5 (L) x 53 (W) x 12 (H)
Included:
- Main PCB (pre-soldered with battery and sensor cables)
Required:
- 2S (7.4V) or 3S (11.1V) battery. 3S recommended for best performance
- SD Card for sound files
- A means of triggering. See the Kytech Industries sensor options, or wire directly into electronic fire control systems/trigger contacts in combination with configuration file settings on the SD card (See manual).
USER MANUAL LOCATED IN THE “DOCUMENTS” TAB ABOVE